2023-Current Toyota Sequoia Rear Recovery Point/Hybrid Bumper Installation Guide

Car front grille, screws, and clips on concrete surface, likely auto repair parts.

Before the installation, remove the factory rear lower plastic cover, revealing the tow hitch receiver.

The cover is held on with clips, it can be easily pulled off by hand.

Machined metallic part with two large circular holes, placed on a workbench in a workshop.

First, install the recovery point into the tow hitch receiver tube. Use any 5/8 inch tow hitch pin to secure it.

Hitch pin NOT included in the kit.

Close-up of a metal assembly with bolts and a latch, painted black, attached to a surface.
Black and gray metal latch or locking mechanism with a curved lower part and a hook on top, isolated on a light gray background.

Next, Insert a provided M12 bolt through each of the CNC blocks, and set it on top of the trailer safety chain hook up points on each side of the hitch receiver, as shown in the picture.

Close-up of the underside of a machine, showing two silver bolts, a black metal frame, and various mechanical parts including a red coil spring in the background.
Close-up of a black metallic frame with brackets and an empty rectangular white label area.

Finally, slide on the hybrid bumper and secure it with 2 of the provided M12 nuts and washers. Use the provided spacer plates as needed to fine tune the fitment.

Torque them down to 75 ft-lbs./101 Nm.

The rear end of a red SUV parked in a parking lot, showing the Virginia license plate, the brand name 'SEQUOIA,' and a trailer hitch.

Enjoy the Recovery Point and the added protection!

Not Your Typical Off-road Parts